1110/1112/i/1600/2310/2610/6030 & Many More Contact Serv
Posted: Fri May 09, 2008 11:28 pm
Hi 2 All Mob. Tech.
If u r suffering from Contact Service while changing SIM IC then dont heat UEM directly if pasted try this method-
1. remove keypad sticker
2.give some heat in the Blue Circle(Shown in picture) i.e. opposite side of UEM.
Then Check ur Mob if OK then Enjoy else reball UEM i think reballing is the last sol.
NOTE- Precaution While Changing SIM IC- Dear put a wet cotton (Dipped in Simple Water) on UEM then change SIM ic it will protect UEM from heat.
If u r suffering from Contact Service while changing SIM IC then dont heat UEM directly if pasted try this method-
1. remove keypad sticker
2.give some heat in the Blue Circle(Shown in picture) i.e. opposite side of UEM.
Then Check ur Mob if OK then Enjoy else reball UEM i think reballing is the last sol.
NOTE- Precaution While Changing SIM IC- Dear put a wet cotton (Dipped in Simple Water) on UEM then change SIM ic it will protect UEM from heat.